This replacement armature is the center component of an electric motor which essentially converts electrical energy into mechanical energy. Due to constant contact with carbon brushes armature will eventually wear out and would need to be replaced. It is a high quality item that is sourced from original equipment manufacturer for use with Makita hammer driver-drills. This item includes an armature, fan, armature bearing and commutator end bearing. It is highly recommended to replace both carbon brushes when replacing an armature. To complete this repair you will need a set of basic tools like a screwdriver and pliers.
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
As described
Product was new took 10 mins to change. Huge savings over a new replacement
Guest - October 14, 2019
Verified Purchase
★★★★★
★★★★★
Oem
Parts are exact oem replacements.....they replaced.the existing burnt out units exactly as the unit came and work s just as good now
Guest - October 17, 2019
Verified Purchase
★★★★★
★★★★★
Easy Repair--Drill works like New!!
The part was delivered extremely fast and it worked like it was supposed to! I was skeptical of the website at first but took a chance and ordered the parts I needed and everything was legitimate. I will definitely be buying more parts from E-Replacement Parts in the future!
Guest - February 17, 2020
Verified Purchase
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.
Easy
15 - 30 mins
(5 rated repairs)?
< Prev
1
Next >
Sort by:
Sorry, we couldn't find any existing installation instruction that matched.
I completely fried my Makita Hammer drill, I had a light when I pressed the trigger so I knew replacing the Armiture and brushes should solve my problem
Simply remove all screws to take the housing apart, slip the gear assembly out of the way, remove the armature. That is the piece with the copper windings. It just pulls out. Replace carbon brushes on the back side, reassemble and power up.
Removed all screws holding casing and power head, separated case removed motor replaced armature, removed brush holder and 2 screws from trigger, installed new brush holder wires on trigger make sure which ones are red and black, re assembled in reverse order total time was maybe 20 minutes, make sure notch on motor lines in with the not
... Read morech in the case.
Read less
Did you find this story helpful?
Thank you for voting!
Brush holder overheated and possible armature damage, after being subjected to tool overloading
Remove screws holding the two cover halves together. Carefully separate the two cover halves, being careful of the hi-lo gear selector switch. Remove brush holder and armature, replace brush holder and armature. Install brushes and reassemble the two cover halves with the hi-lo gear selector switch inserted and being careful to re-positi
... Read moreon the wires into their respective wire ways.
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
