Flat Washer 24 267175-0

Put grease down in hammer to hold the smaller ball bearings into place while I inserted the flat washer on top of the bearings. Then I inserted the
Compression spring on top of the flat washer ,Then I proceeded to put main shaft with the cup washer on it through the compression spring.I used the three jar puller to compress the sp ... Read more ring in the assembly so shaft would push out through the hammer allowing me to put the two larger ball bearings in the two groves in the shaft. Once they were in place I released the pressure on the hammer spring and the assembly was now ready to it back in drill, be sure to apply a small amount of grease on the assembly before putting it back in the drill. Put the assembly back on the drill ,put the four screws back in tighten them down and you\'re done. I was very pleased with all the parts I received .Note : I downloaded the parts assembly of the hammer drill to make sure of the order which the parts went back in.