1. Unscrewed two screws used to secure the switch plate
2. Pull wires off the switch, noting which wire goes where.
3. Using a small flat blade screwdriver, press down on the retainer clip (2 on top and 2 on bottom of switch housing to release them, the push the switch through the metal plate to get it out.
4. Put the ne
... Read morew switch through the metal plate until the retainer clips click into plate.
5. Attach the wires to the switch in the spots they were on the old switch.
6. Put the switch assembly back in place on the drill press body.
7. Install the two retaining screws and tighten by hand.
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW_1.gif "Part Location Diagram of JT9-2852D55723 Jet BULB SWITCH")
_WW_1.gif "Part Location Diagram of JT9-2852D55723 Jet BULB SWITCH")
