This is a genuine OEM sourced armature assembly that is specially designed for Dewalt hammer drill drivers. The armature is the inner portion of the drill motor. This assembly consists of an armature, fan, and two bearings. Symptoms of a bad armature include excessive sparks or smoke coming from the sides of the drill during use. It is highly recommended to replace both carbon brushes when replacing an armature. Remember to be especially careful of the armature fan when you remove it, because if you break it, you will have to replace the entire armature. To replace this armature you would need a screwdriver.
Troubleshooting
This part works with the following brands:
DeWALT
This part works with the following products:
Cordless Drill
Hammer Drill
Impact Driver
★
Customer Part Reviews
?
5.0
Average Rating (out of 5):
★★★★★
★★★★★
(2 Reviews)
Click to filter by ratings:
5 stars
2
4 stars
0
3 stars
0
2 stars
0
1 star
0
< Prev
1
Next >
Sort by:
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
easy fix ,exact replacement
fast service, exact replacement part, ,drill works like new
JOHN - August 11, 2021
Verified Purchase
★★★★★
★★★★★
Exact replacement
Part was a perfect fit. Easy install. Dewalt drill works like new
Guest - September 12, 2022
Verified Purchase
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
Well I over used my drill on a long hot day and it started smoking and blowing chunks of stuff from inside, so I took the shell off the drill and pulled the trigger to be sure what was smoking and to see where all the chunks of melted stuff came from and sure enough the armature assembly was just black and crusty and so I ordered a new on
... Read moree and put it in and it\'s as good as new. Only needed a small torx bit screw driver to do it. It\'s quite self explanatory on how to repair it.
disassembled 2/3 of drill half of transmission removed armature, and brush ring,replaced them, reassembled and applied small amount of grease to transmission, put drill back together (need to loosen screws around speed and clutch controls,adjust so they function properly)tighten everything. Test--use
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
