1 Lay drill on bench and open the drill shell by removing the black Philips head screws
2 Lift up the shell leaving other side and motor laying as they are, be careful of the two springs at battery connector.
3 Disconnect the 2 wires on the back of the motor.
4 Open the chuck all the way and looking inside you can see th
... Read moree screw holding the chuck
5 Remove this screw which is a #15 Torq head and is reverse threaded
6 Unscrew the chuck from the motor shaft and screw it on to new motor
7 Secure it with the reverse threaded screw and place the motor on the shell
8 Connect the two wires noting the red mark on the motor to show polarity.
Replace the shell and install the the phillips head screws removed in step one.
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP10185408
Manufacturer Part Number: 90503089
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
