Part Location Diagram of 054-0235 Powermate Ring Set
See part B-37 in the diagram
( Grid squares measure 1x1 inch )

Ring Set 054-0235

Manufactured by:
Powermate
ERP Number:
ERP9869129
Part Number:
054-0235
Original Equipment Manufacturer ?
  Works with your model  C601H!
$55.71
In Stock
Delivers in 3-5 Business Days!

A Bit Difficult 

1- 2 hours 

(1 rated repair) ?
  Works with your model   C601H!

Troubleshooting

This part works with the following brands:
  • Powermate
  • Industrial Air
  • Husky
This part works with the following products:
  • Compressor

Questions & Answers

?

Our customer Service team is at the ready daily to answer your part and product questions.

Be the first to ask our experts a question about this part!

Ask our Team

We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.

Does this fit my product?

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

A Bit Difficult 

1- 2 hours 

(1 rated repair) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

Compressor was spraying oil from the oil fill/vent tube. Pressurized oil chamber meant bad rings. Factory helped to confirm this before we proceeded with repairs.

Doug from Holland, Michigan

2 of 2 people found this instruction helpful.
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Screw drivers, Socket set, Wrench set
Parts Used:
054-0235, 046-0279
Remove compressor from top of unit, to better access on a bench and fully disassemble top half. Confirm needed parts with available drawings and factory phone assist. Reassemble using new ring set and factory original gaskets ..... we simply used a hose clamp and thin sheet metal to make our own small ring compressor tool.
Pretty s traight forward, add oil and reinstall on top of tank, tighten belts and off an running.
Spent about $85 for parts instead of $600 for new compressor. **One needs some knowledge to do this job, but if you have ever rebuilt and engine this job can almost be done with one hand only. (Figuratively speaking)
We did NOT do the bearing and new crank, we did not see the immediate need for this right now, but that too would be even easier than the top half.
Good luck, it is well worth, as long as you cylinders appear in good shape - as in no scoring on the walls.
Did you find this story helpful?
Thank you for voting!
  • 1