1) Remove screws holding the base to the coffeemaker.
2) Remove base.
3) Remove the two screws holding the bracket that secures the heating element to the heating plate.
4) Remove the bracket.
5) Lift up heating element to gain access to the plate.
6) Remove plate.
7) Remove old disintegrating plastic \
... Read more"ring\" and \"seal\" - a large silicone (?) washer that fits between the \"ring\" and the heating \"plate.\"
8) Installed new ring. It was a snug fit, ensure it get fully seated before going further.
9) Install old seal.
10) Install old plate.
11) Set heating element back in place.
12) Install old bracket and screws, being mindful to not pinch any electrical wires.
13) While bottom cover is off, remove any old feet that are still attached.
14) Install new feet by pulling them through holes with pliers while pushing with thumb.
15) Fit bottom cover and install screws.
16) Test the coffeemaker.
Removed bottom cover
Detached plate holding bracket
Removed plate, ring, and seal and replaced, Ring was very difficult to get in place
Reattached holding bracket
Pulled feet from bottom cover with needle nose pliers and replaced. Feet difficult to insert,
Replaced bottom cover
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP10405609
Manufacturer Part Number: MS-622041
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
