Genuine Bosch/Skil replacement part, this item is sold individually. The screw is used in the Circular Saws shown below to secure the switch handle together. This is a Torx T-25 Screw, but a small flat screwdriver can be used to remove it and install it.
Remove the right handle half from the saw. Make a wiring diagram if you like to. Remove the wires from the switch and remove the switch and cord relief. Connect the wires to the new switch and attach the switch to the handle. Install the cord relief. Then screw the handle half to the saw.
Did you find this story helpful?
Thank you for voting!
Table bent after dropping saw. Handle cracked. Trigger was not working correctly causing a safety issue.
Unscrew handle halves. Remove screws holding handle to saw and remove. Unscrew wires to trigger and remove. Screw handle half to saw that holds trigger. Install trigger wires to new switch and install into handle. Tuck in the wires as not to get pinched and install second half of handle and screw together. Install screws to a fix handle t
... Read moreo saw. Table or foot repair starts with removing depth adjustment screw by removing retaining clip then handle and increasing nut. Remove nut at front of saw at the table. Remove table. Position table onto saw body and screw front screw and nut. Position rear adjustment arch into threaded stud and replace nut. Adjust the nut so the Table can go up and down. Position the lever so down is tight and up loosens enough to adjust depth. Install keeper e clip. On old table remove adjustment nut and install on new table. Just reverse the process to install. Done. Now the saw will cut square and the honey dos will go easy.
Read less
Did you find this story helpful?
Thank you for voting!
Pistol Grip Handle Broke When Saw Fell Off Sawhorse
1. Removed Remaining Broken Handle Pieces From Saw
2. Removed Trigger Assembly From Broken Handle Pieces
3. Installed Trigger Assembly Into New (Pistol Grip Handle)
4. Installed Cord And Anti-Kink Into New (Pistol Grip Handle)
5. Reassemble New (Pistol Grip Handle) With New (Torques Screws)
6. Reattach New (
... Read morePistol Grip Handle) To Saw With New (Shoulder Bolts)
7. Test Saw With New Saw Blade Installed With (Blade Bolt Wrench)
8. Works Beautifully Thanks Guys
Well, first of all, I ordered these parts so long ago it took me a while to remember what they were for. I think I ordered them in late summer--and it\'s now late winter.
The repair was simple and went fine. Parts all fit like new. The old Skilsaw lives again!
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP16649237
Manufacturer Part Number: 5610324001
Saw
- Saw 7-1/4 In. Truehvl Cordless Worm Drive Saw, Saw Blade, Tool Only
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
