Terminal 145332-00

Remove the handle cover
Remove the screw holding the switch
Remove the cord clamp
Remove the cord from the switch
Put the new cord protector on the new cord
Cut and strip the cord leads to length, attach terminals
Install the parts in reverse order

1. Removed Torx screws securing saw handle cover to access power cord terminations.
2. Disconnected spade connector on power cord white wire termination.
3. Removed screw lug on switch to disconnect power cord black wire termination.
4. Removed strain relief, cord mounting clamp and damaged power cord and from saw.
... Read more >5. Stripped new power cord outer jacket insulation and cut black and white wires to lengths matching original cord and installed strain relief and mounting clamp on new power cord.
6.Stripped white wire and installed male crimp spade terminal.
7. Stripped black wire and installed crimp screw terminal.
8. Connected white wire spade connecter and black wire to switch screw lug connector.
9. Routed wires to match original installation.
10. Secured strain relief and cord mounting clamp to saw.
11. Installed saw handle access cover and secured with Torx screws.
12. Tested saw operation.