Spring Cassette Assembly 540057502

For cover snap:
1) Remove broken snap (should just fall out because its broken)
2) Insert new snap in right direction

Starter pulley and cassette:
1) Remove starter cover(some models you might have to remove chain brake handle and or engine cover)
2) Unscrew the screw in the center of the starter pull ... Read more ey and carefully remove
3) If broken unscrew and replace cassette make sure to notice direction it sits in new one must go in the same way
4)After replacing cassette if needed put new rope and handle or move old one onto the new pulley
5)Place pulley back on being careful to set the pulley aligned with the cassette to not bend the spring screw down do not over tighten
6)Rewind the cassette to where the starter rope pulls back in snug and does not hang lose but also is not to tight
7)Replace starter cover and anything else that might have been needed to be removed carefully place the starter cover onto flywheel and turn slightly while pressing down to ensure proper placement of everything