Remove the air cleaner from the saw. Remove the fuel line. Remove the screws that secure the carburetor to the saw. Remove the old carburetor. Install the new carburetor. Tighten the screws. Install the fuel line, then the air cleaner.
Did you find this story helpful?
Thank you for voting!
My chainsaw wouldn\'t idle and wouldn\'t throttle up to operating speed.
I replaced the fuel line and the fuel filter but that had no effect. I ordered the carburetor from you and after putting it on, it started and ran well. The carburetor was adjusted at the factory so no adjustments were necessary. Job done, runs well.
Removed top cover of chainsaw 3 screws
Removed air filter 2 screws
Removed carburetor 2 screws
Removed gas line, throttle linkage, and choke linkage
Reassembled gas line throttle linkage and choke linkage on new carburetor
Put new gasket on engine
Put carb in place
Put 2 screws for carb into block
... Read more Put new air filter in place and put 2 screws in
Put cover on 3 screws
Started saw and runs great!
Got an estimate for 239$ to do repair, did it myself for 41$ and 25 min of my time
Read less
Did you find this story helpful?
Thank you for voting!
Chainsaw fuel line, carb, air filter and spark plug
Parts were all correct. The only challenge was the fuel line because of the design of my Husqvarna chain saw. You have to trade the fuel line from the inside of the gas tank. A u-tube search helped a lot. Thanks
After checking a few things i noticed the carb was not sucking gas through the line . Pulled the plug and put a small amount of gas in and on the plug . It fired right up but only ran a few seconds. Problem solved. Ordered a new carb and gasket. Had a walboro but the zama carb runs like new. Every thing lined up with no problem. Started a
... Read morefter about 6 pulls but only takes 2 or 3 now when cold. If hot starts up first pull. Easy fix and runs like new. No special tools needed except one to adjust carb if needed but it comes preset .Thank you E replacement parts .
Removed top cover, air filter, fuel line, replaced carburetor. replaced in reverse order. Saw started and ran great. Had to adjust idle. Paid two different repair guys to fix this saw $150.00 total. I replaced carb for less than $40.00. problem solved. Thank you.
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW_1.gif "Part Location Diagram of 530035607 Husqvarna CARBURETOR ZAMA W-29")
_WW_1.gif "Part Location Diagram of 530035607 Husqvarna CARBURETOR ZAMA W-29")
