1. Removed bar and chain, cleaned, sharpen the chain.
2. Removed plug, fed rope in plug cylinder hole.
3. Used hammer and bolt to turn clutch clockwise to remove the old clutch, rim sprocket, and bearing.
4. Replaced w/new bearing, rim sprocket , clutch hub.
5. Reassembled.
6. Pulled filter out gas tank w/nee
... Read moredle nose pliers.
7. Replaced w/ the new fuel filter.
Serviced, runs great!
Read less
Did you find this story helpful?
Thank you for voting!
Chain bar not long enough
Alexey from Torrance, California
0 of 1 peoplefound this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
Echo cs-305 chainsaw removed 16-in bar ground down the sprocket on the clutch drum until the larger sprocket would fit over it welded it in place modified 32-in chain bar Oil passages to coincide with the Cs 305 assembled it and everything worked it was very much underpowered obviously but it did the job seven cuts through a 52 inch tree
... Read morestump
Read less
Did you find this story helpful?
Thank you for voting!
The Rim Sprocket broke and actually still ran with 2/3 of a sprocket, but not well.
1. Remove the chain guard nuts, chain guard, bar, and chain loop
2. Use a small flathead screwdriver to pry off the snap ring that holds the rim sprocket and
washer in place, while holding it gently with your fingers so it doesn\'t fly off when it is
released.
3. Don\'t lose the snap ring.
4. Slid
... Read moree off the washer and rim sprocket from the crank spindle.
5. Throw the old rim sprocket in the scrap bin
6. Open package containing the new rim sprocket
7. Install the new rim sprocket to the crank spindle - Oregon logo facing out
8. Install the old washer the way it was
9. Using your strong hands, slip the snap ring back into its groove. You may require some
kind of lever if you are weak and lack such strength.
10. Make sure that none of that shit is going anywhere
11. Install the bar, chain loop, chain guard, and chain guard nuts
12. Set proper tension on the chain loop.
remove bar and chain
remove clutch assy. remember it has left hand threads
remove damaged rim sprocket
install new sprocket and reinstall clutch, bar and chain
adjust chain to specs
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP9067375
Manufacturer Part Number: 682100
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
