This is an original Waring Pro part. This Washer is used on many models of Waring blenders. The Washer is used as a spacer under the Drive Coupling and fits on the shaft of the motor. The washer needs to be replaced if it becomes lost or damaged in any way. The Washer is made of metal and is about a quarter inch in diameter. Tools used: • Screwdriver • Wrench
Remove coupling
Big crescent wrench to hold nut securing blade assbly, smaller crescent to loosen clockwise on bottom of blend. Remove blade assbly, replace 1 rubber gasket, 2 plastic gaskets, 2 stain. Steel washers and small washer under coupling. Use parts diagram to see order of installation, part numbers and quantity needed.
... Read moreReassemble, test for leaks. Voila, remember to tighten/ install button nut counterclockwise.
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW_1.gif "Part Location Diagram of 003507 Waring Washer")
_WW_1.gif "Part Location Diagram of 003507 Waring Washer")
