This rear blade guide assembly is designed to provide essential support and stability for the band saw blade, helping ensure smooth, accurate cuts with reduced vibration. Constructed from durable metal for long-lasting performance, it maintains proper blade alignment and prevents twisting or drifting during operation. Ideal for replacing worn or damaged components, this assembly restores precise cutting control, reduces premature blade wear, and helps deliver consistent results while improving the overall performance of your saw.
The rear blade guide attaches with two allen bolts. One of the bolt holes in the new guide did not have threads. I ran a tap down the hole and it went on easily.
The pulley tires go on a lot easier if you take the pulleys off of the saw.
Did you find this story helpful?
Thank you for voting!
Guides and pulley tires were just worn out and the saw wouldn\'t cut straight.
Removed the blade pulley cover, and removed the broken blade pulley. Placed the pulley tire on the new blade pulley and install the new pulley. Removed the front and back blade guide assemblies and installed the new ones.
Did you find this story helpful?
Thank you for voting!
Throwing a lot of sparks; cutting a little crooked; Cord was cut a few times and was pretty short.
Removed brush cover and old brush; dropped the curved end into brush holder and screwed brush cover back on; Do the same for both brushes. Make sure you have inserted the curved end first.
Remove old cord; remover two screws holding cord clamp in place; disconnect wires; and replace with new cord. I soldered a loop connector on
... Read morethe green ground wire and put solder on the naked ends of the white and black wired. Make sure the cord protector is on. Screw in the cord clamp and screw in the ground wire.
Remove blade and old tires, replace tires aligning groves of tires with knobs on wheels.
Replace front and rear blade guides. Each has two screws.
Replace blade
Removed blade then removed old blade tires then installed new ones making sure the teeth slipped into the grooves on new tire. Then unscrewed and removed the cam followers then installed new ones and reinstalled reversing steps for removal. Reinstalled blade and tested. Works like new now.
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW_1.gif "Part Location Diagram of 42-28-0211 Milwaukee Rear Blade Guide Assembly")
_WW_1.gif "Part Location Diagram of 42-28-0211 Milwaukee Rear Blade Guide Assembly")
