Maytag Washer Hoses and Tubes

The drain hose carries used water from the washer to your house drain.

This part is commonly known to cause a leak at the top left corner of the outer tub. It fits over the injector nozzle.

This injector nozzle is just under three inches long. It is white in color and made entirely of plastic.

The tub-to-pump hose carries the water from the tub to the drain pump. Unplug the washer and shut off the water supply before installing this part. Wear work gloves to protect your hands

This part is the replacement water inlet hose for your washer. It is black in color, made of plastic, and is approximately 19 inches long. The water inlet hose connects the water inlet valve to the water fill nozzle. Over time the hose can become cracked and damaged, and this can cause it to leak. A damaged hose will need to be replaced. Be sure to disconnect the water supply to the washer before ...

This kit contains a top mounting style injector sleeve. It comes with an air gap as well. This part helps stop the contaminated water from being drawn back into the main water line.

This is a replacement tub-to-pump hose for your washer. This hose runs from the bottom of the tub to the water pump, and is used to transport water. The hose can develop a hole, and when this happens you will notice water leaking onto the floor. The tub-to-pump hose is found below the washer tub. To disconnect the hose, you will need to release the clamps that hold it in place with a pair of plier...

This hose goes from valve to inlet.

For drain hose 7/8".

This kit comes with the clamps.

This plastic siphon break comes with a metallic clamp and gasket. It is used with many washing machines.

This dispenser hose is for washers and carries the contents of the dispenser drawer to the washer tub.

The part includes the hose, water injector and clamp.

This drain hose is 42" long and includes the clamps.

This hose goes from the drain pump to the back of the washer.

This hose attaches to water pump assembly. NOTE: As per the manufacture if the washer has an Eco Ball, it's no longer needed when the new hose is installed.

This hose can handle hot or cold water and is five feet long.

This is a top mounting style injector sleeve.