Maytag Washer Hardware

If you notice that your dryer is noisy or will not tumble, you may need to replace the tri ring. This part is triangular, and is less than an inch in size. Tri rings can be found both on the idler pulley shaft, or on the rear drum roller shaft. In either case, you will need to remove the front panel of the dryer and the drum to access the part for repair. Once you have accessed the damaged tri rin...

This kit contains one screw with rubber gasket and threaded sealant. The screw head is 7/16".

This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.

This screw is sold individually.

This part goes on the agitator retaining bolt.

This part is used for the shaft on rear of the tub. Sold individually.

Sold individually.

The door boot spring clamp holds the door boot in place.