KitchenAid Washer Hardware

This kit contains one screw with rubber gasket and threaded sealant. The screw head is 7/16".

This part goes on the agitator retaining bolt.

This is a replacement suspension spring retainer for your washer. The retainer holds the suspension spring in place while the washer is operating. If you notice movement, or an unusual noise or shaking of your washer when it is in use, it could mean that the suspension spring has been disconnected because of a broken or missing spring retainer. You will find the suspension spring retainer at the b...

This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

This screw is sold individually.

This hose clamp is sold individually.

Right hand threaded nut holds the tub in place in direct drive, top loading washing machines. To remove the spanner nut you will need a spanner wrench.

This is the replacement bellow clamp for your washer. It approximately 16 inches in diameter and is sold individually. The bellow clamp goes around the bellow in your washer and holds it in place on the washer frame. The main reason you would want to replace the bellow clamp is if it is rusted or damaged, and it is not holding the bellow into place. To remove the bellow clamp, simply use a screwdr...

Sold Individually.

Sold individually.

Used to help hold your bellow in place on your washer.

Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.

Metallic screw that is less than an inch long. Does not include the plastic washer.

CLIP-TOP&CAB-R PNL

Fits under the basket drive assembly.

Sold individually.

Used to put a space between the cabinet and the top of the washer.

This screw is sold individually.