Kenmore Washer Hardware

This kit contains one screw with rubber gasket and threaded sealant. The screw head is 7/16".

This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.

This part goes on the agitator retaining bolt.

This part is used for the shaft on rear of the tub. Sold individually.

Sold individually.

This is a replacement suspension spring retainer for your washer. The retainer holds the suspension spring in place while the washer is operating. If you notice movement, or an unusual noise or shaking of your washer when it is in use, it could mean that the suspension spring has been disconnected because of a broken or missing spring retainer. You will find the suspension spring retainer at the b...

Sits in between the agitator base and upper agitator.

Sold individually.

This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.

This washer shock absorber mounting pin is a small but essential fastener that secures the shock absorber to the outer tub of a front-load washing machine. By holding the shock absorber firmly in place, it helps stabilize the tub during wash and spin cycles, reducing excessive vibration, shaking, and movement. Made from durable materials and designed for a precise fit, the pin supports smooth oper...

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Sold individually.