Inglis Washer Valves

This water inlet valve is for washers. The water inlet valve controls the water flow into the washer. Unplug the washer and shut off the water supply before installing this part. Wear work gloves to protect your hands.

This part is used to help control and balance the water temperature flowing in to the washer tub.

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.

Water inlet valve controls the water flow into the washer. Fits some washers in the following series: Kenmore 110; Whirlpool CHW, WFW and YWFW; Maytag CHW, MHN, MHP, MHWE, MHWZ and YMHWE; Amana NFW and YNFW; and Inglis IFW and YIFW. Also fits some laundry centers in these series: Whirlpool CET and CGT; and Maytag MLE and MLG.

Restore your washer’s performance with this water inlet valve. It controls water flow and temperature, so if your machine isn’t filling, is leaking, or takes too long to fill, this part is the fix you need. Easy to install and built for dependable operation.

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed. W/Bi-Metal

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed. Sometimes these valves are called mixing valves, because they essentially mix the cold and hot water together to create “warm” water. Another common term is water solenoid.

This water inlet valve assembly is for washers. Water inlet valve assembly controls the water flow into the washer. The assembly may include multiple parts; refer to your parts diagram for a complete list of parts included. Unplug the washer and shut off the water supply before installing this part. Wear work gloves to protect your hands.

This part is the replacement hot water valve for your washer. It is approximately 2-1/2 inches by 3-1/2 inches, and the valve head is approximately 1 inch in diameter. The hot water inlet valve in your washer connects to the water source and solenoid wires, and ensures the tub has the right amount of hot water entering it. If your washing machine continues to fill after it is full, or if it fills...