Crosley Washer Hardware

This kit contains one screw with rubber gasket and threaded sealant. The screw head is 7/16".

This part goes on the agitator retaining bolt.

Sold individually.

The door boot spring clamp holds the door boot in place.

This is a replacement suspension spring retainer for your washer. The retainer holds the suspension spring in place while the washer is operating. If you notice movement, or an unusual noise or shaking of your washer when it is in use, it could mean that the suspension spring has been disconnected because of a broken or missing spring retainer. You will find the suspension spring retainer at the b...

Sits in between the agitator base and upper agitator.

Sold individually.

This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.

This washer shock absorber mounting pin is a small but essential fastener that secures the shock absorber to the outer tub of a front-load washing machine. By holding the shock absorber firmly in place, it helps stabilize the tub during wash and spin cycles, reducing excessive vibration, shaking, and movement. Made from durable materials and designed for a precise fit, the pin supports smooth oper...

This screw is sold individually.

This hose clamp is sold individually.

Washer

This idler shaft retaining ring is well under an inch long and is made of metal.

This washer door boot spring clamp secures the rubber door seal in place, maintaining a tight, watertight fit between the tub and front panel during operation. Its tension design helps prevent leaks and keeps the door properly sealed throughout wash cycles. Replacement is recommended if the seal becomes loose, water leaks from the front, or the clamp is damaged, helping restore a secure fit and re...