Westinghouse Refrigerator Switches

This micro switch is a replacement electrical component that detects position or movement and sends signals to control functions. It is commonly replaced when an appliance does not respond correctly to door or control actions. Proper application should be verified prior to installation.

This start relay supplies the initial electrical boost needed to start the motor reliably. Proper startup reduces strain and supports smooth operation. Replacing a faulty relay restores dependable motor starting.

This is the replacement light switch for your refrigerator. It is white in color and is approximately 2inches long and 1 inch wide. If the light is not working or stays on, you may need to replace the switch. It is an OEM part, directly from the manufacturer. Be sure to disconnect the refrigerator from the power source before you begin this repair. To remove the switch, simply use a flathead screw...

This is a switch for your refrigerator, but you may also know it as a door switch or a plunger light switch. This part turns your appliance light on and off as the door is opened and closed. If your current light does not turn on, it will need to be replaced. To make this repair you will need a Phillips head screwdriver, a putty knife, and a flat head screwdriver.

This part turns the light on/off as the door opens and closes.

This light switch controls interior lighting by activating when the door is opened or closed. It is commonly replaced when the light fails to turn on or off properly, helping restore correct lighting operation.

This part allows the cold air from the freezer section to be aired into the fresh food section and it is controlled by the thermostat.

Compressor start relay kit is an original equipment manufacturer (OEM) part that fits some Kenmore, Frigidaire, Electrolux, Crosley, Gibson and White-Westinghouse refrigerators. It also fits some Kenmore, Frigidaire and Gibson upright freezers. Compressor start relay kit includes the compressor start relay, run capacitor, wire harness adapter, 2 wire terminals, 2 wire connectors, 2 pieces of wi...

This part is both the start relay and the overload. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed and the overload provides extra protection against excessive temperatures.