General Electric Refrigerator Ice Makers

The ice maker receives water from the water inlet valve and will freeze until ice cubes are formed. Once the water has been frozen the cubes will be ejected from the mold into the ice bucket.

This ice container assembly is a genuine OEM replacement part for your refrigerator. This kit includes the container that holds the ice, along with the auger and blades. Replacing this assembly is an easy repair that does not require any tools. First turn the ice maker off, then remove the old container from the freezer. Line up the connector with the auger yoke, then slide the new container into ...

This is the replacement bucket auger for your refrigerator. It is approximately 20 inches long and 14 inches wide. The bucket auger sits within the ice maker assembly and rotates to push the ice from the ice container into the dispenser chute. If your ice maker bucket is full, but ice is not being dispensed, it is an indication that the auger is damaged. Be sure to disconnect power from the refrig...

Ice Bucket and Auger

This part is the replacement heat-release ice maker unit only. This kit comes with four round female connectors at the end of the wire harness. It also comes with the adaptor that converts the harness to three round female and one round male connectors.

This icemaker contains the complete ice maker and housing. The assembly may include multiple parts; refer to your parts diagram for a complete list of parts included.

This genuine replacement ice dispenser drum is designed for use with a wide range of refrigerator models. Made from durable plastic, the drum plays a key role in your ice maker by capturing ice and directing it to the crusher for dispensing. It is positioned between the ice dispenser drive plate and the ice crusher mounting plate, ensuring smooth and efficient operation. If the drum becomes dam...

This ice maker assembly in your bottom-freezer refrigerator automatically produces and dispense ice. It consists of a mold for 9 ice cubes, a control device, and a 12-pin wiring connection and housing. Its dimensions are approximately 4-1/2 inches by 12-3/4 inches by 4-1/4 inches, and it can produce about 84 ice cubes within 24 hours. This genuine OEM assembly is sold separately from the water lin...

Icemaker kit - electronic. Includes 4 pin round plug-in connector, 6 post plug-in connector, fill cup and tube.

This part is white in color.

This genuine OEM ice container, also known as an ice bucket, is designed for use in refrigerators to store ice cubes. It should be replaced if it develops significant cracks or breaks that could affect performance. To remove the container, open the freezer door and lift it out, ensuring the ice maker’s shut-off arm is in the off position. Transfer the front panel, access door, shield, crusher asse...

Ice Bucket and Auger

This part is found at the end of the auger in the ice container - replace this part when the icemaker doesn't dispense ice.

The cube solenoid allows cube or crushed ice to be dispensed on demand. 120V 60Hz