General Electric Refrigerator Dispensers

This part mounts in the ice dispenser. The crank no longer comes with this part but you can use original crank. The crank is sold separately depending on the model number of your appliance.

An ice chute is mounted to the interior panel and extends between the interior panel opening and the dispenser opening for transferring ice through the chute door.

NOTE: Control board is NOT included. Must be ordered separately.

Once a glass is pressed against the actuator pad it will cause the dispenser to deliver ice or water when activated.

Designed to create a secure seal within the ice dispensing system, this genuine OEM ice chute door flap helps maintain proper freezer conditions by preventing warm air from entering the compartment. Its flexible, durable construction allows it to close tightly over the dispenser opening, reducing moisture intrusion and minimizing frost or ice buildup. Built for a precise fit and reliable performan...

This part is the replacement dispenser grille for your refrigerator. It is made of black plastic and is approximately 10 inches wide and 4 inches deep. The dispenser grill sits at the bottom of your ice dispenser assembly and catches any spills when your ice or water dispenser is running. If your dispenser grille/drip tray is missing or damaged, this is the part that replaces it. To replace the di...

This dispenser door flap opens and closes during dispensing to help contain internal airflow and prevent spills or drips. A properly sealing flap supports efficient operation and clean dispensing performance. Replacing a cracked or damaged flap restores smooth dispensing, reduces mess, and improves overall usability.

This grey drip tray is designed to catch excess water or ice from your refrigerator’s dispenser, helping prevent spills on the floor and maintain a clean, hygienic space. Made from durable plastic, it withstands everyday kitchen use and is easy to remove for cleaning. Installation is simple—just slide the tray into place for a secure fit. Ideal for replacing a worn or missing tray, it ensures your...

This paddle, when your glass is pushed against it, activates the dispenser to release the ice through the funnel.

This crank door recess is supplied directly from the original equipment manufacturer. The plastic part is fastened behind the interface dispenser assembly in the freezer door. Activated by the dispenser solenoid, this part regulates the opening and closing of the ice chute door. A screwdriver is needed for the repair. The crank door recess is sold individually.

This part is a replacement recess grille tray for your refrigerator. This recess grille tray sits below the ice and water dispenser, and collects any spills. If your dispenser grille tray is broken or missing, this is the part that replaces it. This part is made of black plastic and is approximately 7 inches wide. It is sold individually and is an OEM part from the manufacturer.

This ice chute funnel helps guide ice smoothly from the dispenser into your glass, reducing spills and preventing jams. Made from durable plastic, it’s a simple replacement when the original funnel becomes cracked or damaged. Designed to match the original fit and function, it installs easily using the built-in locking tabs.

Assembly CASE-ICE ROUTE This dispenser ice chute door and funnel assembly is for refrigerators. Dispenser ice chute door and funnel assembly opens to let ice through when dispensing into a glass or other container. The assembly may include multiple parts; refer to your parts diagram for a complete list of parts included. Unplug the refrigerator and safely store any food that could deterior...

This dispenser housing shield kit contains genuine replacement parts. It includes the dispenser funnel, frame, spring, and the hardware you will need to install it. The funnel and frame are made out of black plastic. Before installing a new dispenser make sure you shut the water supply off and unplug the refrigerator.