Crosley Refrigerator Dispensers

Restore full control of your refrigerator’s dispensing system with this dispenser module, designed to manage the delivery of water, crushed ice, and cubed ice directly from the door. Featuring a complete assembly with cradle, ice chute, and chute door, it ensures smooth and reliable operation for everyday use. Built for a precise fit and dependable performance, this component is an ideal solution ...

An ice chute is mounted to the interior panel and extends between the interior panel opening and the dispenser opening for transferring ice through the chute door.

*Please note, this door chute is no longer being manufactured with a heater.

Once a glass is pressed against the actuator pad it will cause the dispenser to deliver ice or water when activated.

Designed to create a secure seal within the ice dispensing system, this genuine OEM ice chute door flap helps maintain proper freezer conditions by preventing warm air from entering the compartment. Its flexible, durable construction allows it to close tightly over the dispenser opening, reducing moisture intrusion and minimizing frost or ice buildup. Built for a precise fit and reliable performan...

This part is the replacement dispenser grille for your refrigerator. It is made of black plastic and is approximately 10 inches wide and 4 inches deep. The dispenser grill sits at the bottom of your ice dispenser assembly and catches any spills when your ice or water dispenser is running. If your dispenser grille/drip tray is missing or damaged, this is the part that replaces it. To replace the di...

This dispenser door flap opens and closes during dispensing to help contain internal airflow and prevent spills or drips. A properly sealing flap supports efficient operation and clean dispensing performance. Replacing a cracked or damaged flap restores smooth dispensing, reduces mess, and improves overall usability.

This grey drip tray is designed to catch excess water or ice from your refrigerator’s dispenser, helping prevent spills on the floor and maintain a clean, hygienic space. Made from durable plastic, it withstands everyday kitchen use and is easy to remove for cleaning. Installation is simple—just slide the tray into place for a secure fit. Ideal for replacing a worn or missing tray, it ensures your...

This black dispenser cover provides a clean, finished look for your refrigerator’s water and ice dispenser area. Built for durability, it protects internal components while enhancing the appliance’s appearance.

This dispenser front panel provides a clean, accessible interface while protecting internal components. Its durable design supports frequent use and visual consistency. Replacing a cracked or worn panel restores ease of use and appearance.

In addition to the solenoid (115V), this kit also comes with a door strike and an ice door assembly. Please be advised the spring and roll pin are not included with this kit.

This is the ice actuator or ice actuator arm for your refrigerator. When you depress the actuator arm with a glass or bucket, ice is normally dispensed. If your current actuator arm is broken, missing, or if the ice dispenser isn’t dispensing ice, you may need to replace it. To access the actuator, you will first need to remove the dispenser assembly, and then remove the actuator from the assembly...

This is just the cover. Label module cover must be ordered separately.

This black dispenser grille catches any overflow from the ice/water dispenser.

This ice actuator is a replacement mechanical component designed to initiate or control ice release during dispensing. It supports smooth, responsive operation and is commonly replaced when ice fails to dispense properly.

This part is located at the base of the dispenser bay catches small spills and allows them to evaporate. The drip tray is removable for easy cleaning.

Once a glass is pressed against the actuator pad it will cause the dispenser to deliver water when activated.