Jenn-Air Range Switches

This infinite switch for eight inch range burners is almost three inches long. This infinite switch is for 8-inch range burners. When an element is unable to produce any heat on a modern oven, the problem may lie with the infinite switch. This switch is responsible for sending power to the surface elements. Check the element and terminal block to ensure they are working properly. If they are in wo...

This is a push-and-turn switch. This kit includes all necessary hardware to install the part. Switch comes with a D-shaped shaft.

The surface element control switch adjusts the heat output of your stovetop burner. It has a double flat shaft and is nut-mounted for secure fitting. Ensure compatibility before ordering.

This switch is used to operate the dual surface burner.

Sold individually.

This surface element control switch is for ranges. Surface element control switch turns the surface element on and off and controls how much heat the element produces. Unplug the range or shut off the house circuit breaker for the range before installing this part. Wear work gloves to protect your hands.

This part has been updated by the manufacturer. This updated part now has 7 wire terminals instead of 5. The terminals are all labeled, however, the new switch needs to be tested before connecting the pilot lamp wire (P). To test the new switch: 1) Connect the Line Wires (L1 and L2), connect the Load Wires (H1 and H2). 2) Do not connect the pilot lamp (P) wire yet. 3) Reconnect the power to the...

This surface element switch controls the heat level for a stove burner. Replace it if the burner won’t turn on, won’t heat, or stays on high. Disconnect power before installation.

This is a switch that operates a solenoid that closes a circuit to operate the starter

This temperature limit switch monitors operating temperatures and interrupts power if unsafe heat levels are reached. It helps protect internal components from overheating and is commonly replaced when heating functions shut down unexpectedly.

These switches mount on the surface valve. When the gas burner valve knob is depressed and turned, this part creates a spark that lights the gas and starts the burner