Maytag Dryer Wire Plugs and Connectors

This part is an electrical connector where you can attach wires. This part does NOT included the wires, screws, and nuts. Must be order separately

This terminal block assembly does not come with any hardware. It it three inches long and made of plastic and metal.

This kit comes with two ceramic insulators.

If your dryer isn’t heating properly, this terminal and wire kit can help. It replaces damaged or loose wires that connect to the terminal block, restoring the electrical connection so your dryer works like it should. The kit comes with wires, screws, and wire nuts—everything you need except the terminal block. Just swap out the old wires and secure the new ones for a quick, reliable fix.

This belt switch jumper wire is for dryers and takes the place of the belt switch in some models produced without the switch.

This wire harness connects the moisture sensor to the control system, allowing accurate detection of moisture levels during drying. Proper sensor feedback helps prevent over- or under-drying. Replacing a damaged harness restores accurate sensing and cycle performance.

Three temperature rotary switch.