Kenmore Dryer Hardware

If you notice that your dryer is noisy or will not tumble, you may need to replace the tri ring. This part is triangular, and is less than an inch in size. Tri rings can be found both on the idler pulley shaft, or on the rear drum roller shaft. In either case, you will need to remove the front panel of the dryer and the drum to access the part for repair. Once you have accessed the damaged tri rin...

This mounting screw is a genuine OEM replacement part for the door handle in your refrigerator. If you are having trouble shutting the refrigerator door, or opening it, replacing this screw can help solve the issue. Replacing this part is easy and requires minimal disassembly of the refrigerator end cap handle. Your will need a screwdriver to complete this repair.

This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.

This screw is sold individually.

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

This screw is sold individually.

Sold Individually.

This manufacturer-approved screw is for refrigerators, including Kenmore refrigerator model. Avoid cross-threading refrigerator screw during installation.

This fastening nut secures components firmly in place, helping maintain proper alignment and safe operation. It is commonly used as a replacement when original hardware is stripped, lost, or damaged.

This kit includes 3 screws and 3 nuts.

Sold Individually.

Sold individually.

This part is used to secure the top panel to the cabinet. Sold individually.

This clamp is used to secure the drive motor.

This metal motor mounting clamp helps keep the dryer’s motor securely in place, reducing vibration and supporting smooth drum rotation during each cycle. It’s a direct OEM replacement for a damaged or missing clamp and can help resolve issues such as loud noise, shaking, or a drum that won’t turn properly. Designed for select dryer and laundry-center models, it restores stable motor alignment and ...

Metallic screw that is less than an inch long. Does not include the plastic washer.

This is a replacement screw for your washer or dryer. The screw is approximately half an inch in length and is a Phillips-head screw. It screws in from the outside of the drum, into the vane/baffle. The main reason you would replace this screw is if the old screw is missing or damaged. This part is sold individually and is an OEM part sourced directly from the manufacturer.