Estate Dryer Hardware

If you notice that your dryer is noisy or will not tumble, you may need to replace the tri ring. This part is triangular, and is less than an inch in size. Tri rings can be found both on the idler pulley shaft, or on the rear drum roller shaft. In either case, you will need to remove the front panel of the dryer and the drum to access the part for repair. Once you have accessed the damaged tri rin...

This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

This screw is sold individually.

Sold Individually.

This kit includes 3 screws and 3 nuts.

Sold Individually.

Sold individually.

This part is used to secure the top panel to the cabinet. Sold individually.

This clamp is used to secure the drive motor.

Metallic screw that is less than an inch long. Does not include the plastic washer.

Sold individually.

Sold individually.

Sold individually.

This screw is sold individually.

This kit includes 2 bumpers and 2 locking clips.

Sold individually.

This screw is sold individually.