Crosley Dryer Hardware

If you notice that your dryer is noisy or will not tumble, you may need to replace the tri ring. This part is triangular, and is less than an inch in size. Tri rings can be found both on the idler pulley shaft, or on the rear drum roller shaft. In either case, you will need to remove the front panel of the dryer and the drum to access the part for repair. Once you have accessed the damaged tri rin...

This metallic retaining ring is less than an inch in diameter. It is made entirely of metal.

This idler pulley shaft washer is used with many clothes dryers. It is less than an inch long, and it is black in color.

This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.

This roller shaft washer is just under an inch in diameter and is used for some of Whirlpool's brands of clothes dryers.Sold individually.

This screw is sold individually.

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

This roller shaft hex nut measures well under an inch long. It is made of metal and is used for Maytag brand clothes dryers.

This screw is sold individually.

This idler shaft retaining ring is well under an inch long and is made of metal.