Kenmore Dishwasher Caps and Lids

This rail end cap, or dishrack stop clip, is a genuine OEM replacement part for your dishwasher. This part keeps the rack in your dishwasher from sliding out. This is a very easy repair, to complete it you only need a flat blade screwdriver. Use the screwdriver to pry the locking tab open on the cap, located at the front of your upper dishrack. Pull off the end cap and lock the new one into place.

The rinse aid cap (sometimes referred to as the dispenser cap), covers the rinse aid dispenser on the dishwasher door. If your dishwasher will not dispense detergent, or it is leaking detergent, there could be an issue with the rinse aid cap. Check the cap and its gasket for any damage or melting. If the cap has melted or it is not sealing the dispenser properly, the part should be replaced right ...

This is a replacement cap for the detergent/rinse aid dispenser. If the rinse aid cap is damaged or missing, you may notice too much rinse aid in the dishwasher. The cap simply screws into the dispenser, so if your cap is damaged you can simply screw it out, then screw in the new one. The rinse aid cap is approximately 2 inches in diameter and is sold individually. This is an OEM part, directly from the manufacturer.

This cap does not require the use of a o-ring seal.

The plastic button covers the sharp ends of screws along the edge of the dishwasher tub. Sold individually.

This part helps keep the rinse aid the dispenser until its needed.

This rinse aid cap or fill cap is for your dishwasher and it screws into the jet dry dispenser. Sometimes the cap can become loose and fall out, which can cause it to melt from the heater. If your cap is damaged or missing, this is the part you will need to replace it. It is made of white plastic and is a little more than an inch in diameter. This rinse aid cap is sold individually.

The rinse-aid dispenser cap is an original equipment manufacturer (OEM) part that fits Kenmore 665-series and Amana ADP1400-series dishwashers.

This dishwasher detergent dispenser cover helps seal the detergent compartment and ensures detergent is released at the correct point during the wash cycle. Designed with an integrated gasket for a secure fit, it replaces lids that are cracked, leaking, or no longer latching properly. Installing a new cover can resolve issues such as detergent not dispensing, leaks from the dispenser, or a broken ...

This sump cap cover protects the dishwasher’s pump area by keeping debris out and helping maintain proper water flow for effective cleaning. It’s a quick, reliable replacement when you’re experiencing issues like leaks or poor wash performance, and it installs easily on select models. Be sure to check your dishwasher’s model details before purchasing to ensure the right fit.