General Electric Dishwasher Hoses and Tubes

This coupler, also known as a hose connector, is made of white plastic and is about one inch in height, and just over one inch in length. Replacing the coupler is a fairly easy repair. The hardest part of the repair is accessing the spray arm and filter to remove them, in order to replace the coupler. In order to complete this repair, you will need a flat head screwdriver and a 4-inch nut driver.

This part is used to connect your dishwasher to your sink faucet.

This kit includes the drain hose with black rubber end fittings and a clamp.

This elbow hose and clamp kit provides a secure connection for routing fluids or air. Designed for a tight fit and dependable sealing, it supports reliable flow management.

This conduit adapter attaches to the central wash arm in your dishwasher to allow the arm to clean dishes thoroughly and properly. This genuine OEM adapter is made of high quality plastic and measures approximately 6 inches long by 4.5 inches wide.

This drain hose is an OEM, manufacturer-approved replacement part for your dishwasher. The drain hose filters out the wastewater from the dishwasher. If there is a hole in it, water will leak out of your dishwasher. Shut off the water and power to the unit before beginning this repair. Accessing the drain hose involves unscrewing the dishwasher and pulling it out. Remove the clamp holding the hose...

This part is used to attach the drain & fill hose of your portable dishwasher to your faucet.

This drain house is 12 ft long.