Part Location Diagram of 626891-01 DeWALT Warning Label
See part 30 in the diagram
( Grid squares measure 1x1 inch )

Warning Label 626891-01

Manufactured by:
DeWALT
ERP Number:
ERP10182631
Part Number:
626891-01
Original Equipment Manufacturer ?
  Works with your model  D28065!
$5.95
Special Order

A Bit Difficult 

15 - 30 mins 

(1 rated repair) ?
  Works with your model   D28065!

Product Description

?

This is an authentic OEM part. The warning label provides important safety information to avoid hazardous situations. The label sticks into place on DeWalt grinders therefore, no tools will be required to install or replace the label. This part is made of plastic and is sold individually.

Troubleshooting

This part works with the following brands:
  • DeWALT
This part works with the following products:
  • Angle Grinder

Questions & Answers

?

Our customer Service team is at the ready daily to answer your part and product questions.

Be the first to ask our experts a question about this part!

Ask our Team

We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.

Does this fit my product?

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

A Bit Difficult 

15 - 30 mins 

(1 rated repair) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

Mainly repaired for cosmetic reason, case had labels that had worn off

Domingo from Baytown, Texas

0 of 1 people found this instruction helpful.
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Replacing the case is very straight forward, remove the four screws that hold gear case, remove all screws that hold halves of rear case assembly, remove armature assembly and field after disconnecting leads, remove the brush holders and brushes after disconnecting them, remove brush terminals and reinstall on new case, install the little flat coil springs on new case, this is the only part that was a little difficult for me since they are small and can only go in one way since the sit in case that secures them is closed on one side, then it is a simple matter to reverse disassembly procedure, grinder now looks as new!
Did you find this story helpful?
Thank you for voting!
  • 1