This authentic OEM sourced component is specially designed for DeWALT and Black and Decker power tools. The switch allows a user to turn the unit on and off, unfortunately, over time parts will wear out and may begin to fail eventually requiring a replacement. Keep in mind this high-quality plastic body switch is sold individually. Please make sure to refer to the appropriate diagrams of your model for the correct location and installation of this part.
Troubleshooting
This part works with the following brands:
Black and Decker
DeWALT
DeVilbiss
This part works with the following products:
Angle Grinder
Part# 5140028-48 replaces these:
5140028-48,
Customer Repair Instructions
All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.
Easy
Less than 15 mins
(4 rated repairs)?
< Prev
1
Next >
Sort by:
Sorry, we couldn't find any existing installation instruction that matched.
Removed the handle, removed the wires and one screw holding old switch. Studied the new wiring diagram. Switched wires to replicate the diagram on the new wiring sheet. Tightened the wiring screws and reinstalled switch. Screw the handle plugged it in and used it. What took the most time was finding a small enough metal object to insert
... Read moreinto old switch to get the wires out with out cutting and this shortening them.
Replaced 4 terminal switch but same terminals were in a different position, and it was good that a wiring diagram was included to explain the difference.
Did you find this story helpful?
Thank you for voting!
Power cord was old & cracked and the switch no longer worked.
Remove the three screws that go through the side of the handle and two screws that attach the removable side of the handle to the motor housing. Separate the handle. Cut the wires from the motor and power cord close to the switch leaving as much wire to work with as possible. Remove the screw holding the switch to the grinder housing a
... Read morend remove the switch. Strip about 3/8 inch of the insulation from the end of the motor wires and with the screws provided, attach to the lugs on the switch labeled \"Field\" (per instructions included with the new switch) and similarly attach the power cord wires to the \"Cord Lead\" lugs on the switch. Secure the new switch into the housing replacing its screw. Tuck the wires into the appropriate cavities and reattach the handle.
Remove the screws from handle assembly, remove the switch from handle. Take note on how the switch is wired. Remove the wires from the old switch and replace them on the new switch. Attach switch to handle. And replace both handles.
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP10176916
Manufacturer Part Number: 5140028-48
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
