This item is a genuine Makita part that has been sourced from the original manufacturer to be used with trimmers, circular saws, sanders, routers, nailers, reciprocating saws, laminate trimmers, and planers. The flat washer is used with different types of power tools and the application of the washer can vary based on the model of the equipment. This item is available as an individual replacement part.
This is an authentic Makita replacement part that has been sourced from the original manufacturer to be used with circular saws, table saws, masonry saws, planers, demolition hammers, and angle cutters. The washer has multiple applications based on the model of the power tool. It is recommended to review your model's diagram to verify this washer's compatibility. The washer is sold individually.
This part is available individually. The spring washer fits between the wing nut and the flat washer. This washer is small and will need to be replaced if it gets lost or if it breaks. It is made out of metal and no tools should be necessary when replacing this item. This is an OEM Makita part directly sourced from the manufacturer for use with saws, cutters, planers, drills, and trimmers.
This genuine manufacturer-sourced part is specially designed for Makita power tools. It is an important component which provides a tight seal between connected components. Unfortunately, over time it will wear out and it may begin to crack eventually requiring a replacement. To ensure the correct repair procedure, refer to the appropriate diagrams for your model. Note, this high-quality insulation washer is made of durable material and is sold as an individual item. A screwdriver will be needed to take apart and reassemble the tool when performing this repair.
It is made out of metal and is sold individually. The wave washer fits between the labyrinth rubber ring and the magnet sleeve. A set of pliers and a screwdriver might be helpful during the installation of this part. It will require replacing if it breaks. This is a genuine Makita part sourced directly from the manufacturer for use in sanders, grinders, trimmers, and saws.
This is a genuine Makita replacement part that has been sourced from the original manufacturer to be used with circular saws, miter saws, and laminate trimmers. The washer is used for spacing and to disperse the pressure put on a part assembly by a nut or bolt across a wider surface area. This item is sold individually, please see your model's illustrated diagram for the washer's location and usage.
This is an authentic Makita replacement part that has been sourced from the original manufacturer to be used with laminate trimmers. The metal washer is used to provide spacing between the lock lever support pin and the base assembly. This item is available as an individual replacement part.