This ball bearing is assembled by the original manufacturer. It is used in a variety of Powermatic, Jet, and Wilton power tools. Ball bearings serve to protect moving parts from wearing each other down and from damage due to incorrect position/direction. This is a high-wear part and will need regular replacement. This part is sold individually.

This is an Genuine Manufacturer Authorized replacement part used on variety of power tools. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This is a genuine manufacturer approved replacement switch used on a variety of power equipment. It is the part of the tool handling on/off operations. Since switches have moving mechanical parts, they will eventually wear out and will require a replacement. Switch has a plastic body and it is sold individually.

To replace this switch you would need a screwdriver.

• Remove screws used to hold switch cover
• Disconnect wires from the old switch and remove it from the housing
• Place the new switch in the housing and connect wires to it
• Reassemble the housing

This is an OEM Authorized replacement part used on variety of power tools. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This is a genuine OEM sourced replacement part designed for use with Jet mini lathe. This lead screw helps to secure the spindle pulley. This item is made out of metal and it is sold individually. Please note the set screw used to secure it is sold separately. To complete this repair you would need a hex key/allen wrench.