Clipper Parts

Genuine Oster Pro replacement part, this item is sold individually. It includes two leads with it. The switch to a electric tool is one of the most common replaced parts. Eventually a switch will degrade and not operate any longer. It is advised to order an extra switch to keep on hand.

Genuine Oster Pro replacement part, this product is sold in a set of two. It also includes the Brush Springs. It is used on the Clipper models shown below. Replacing brushes can fix a motor that’s operating intermittently. Carbon brushes are one of the most commonly replaced power tool parts. A worn-out brush will often be worn down and can be cracked, pitted, or burned. If a Brush is burned or scored, it is advised to inspect the armature and field for damage.

Genuine Andis replacement part, this item is sold individually.
The purpose of the 26899 Screw is to secure the Blade to the Clipper/Trimmer model numbers shown below.
Two of the screws are needed on each model.

This is an OEM part from Andis. The Blade Drive is used on many Andis clippers. This part is used to drive the cutter on the blades to cut hair. This part should be replaced if any of the flexible tabs have broken loose or if the tip has worn out. Included with this part is instructions on how to correctly replace the Blade Drive.

Tools used:
• Philips Head Screw Drivers
• Flat Head Screw Drivers (To help pry old part off)

This is a genuine OEM sourced replacement part designed for use with Andis clippers. This assembly includes one (1) carbon brush with a lead wire attached. Please note brush spring and retaining clip are both sold separately.

Due to normal use and friction brushes will gradually wear down and will require replacement. It is advised to replace both brushes at the same type.

You would need a screwdriver to complete this job.

• Make sure the unit is unplugged
• First remove cover
• Take our old brushes and replace them with the new ones
• Secure the cover and test the tool