Generator Parts

This is a genuine Milwaukee replacement part, it is sold individually.
The most common use of the 06-75-2402 Screw is to hold the 42-68-0073 Blade Clamp to the reciprocating spindle on the Milwaukee Sawzalls shown below.
It is used in a few other Milwaukee products

This is a genuine OEM replacement part, it is sold individually.
The purpose of this filter is to help eliminate dirt, dust and debris from contaminating the carburetor and damaging the engine.
A dirty air filter can cause the engine from operating properly.
This filter can be cleaned a time or two by using an air supply. But it is advised to replace it once it becomes dirty.

This is an OEM replacement part and is sold individually.
Its propose is to deliver an electric current from an ignition system to the combustion chamber of a gas fueled engine.
It will ignite the air fuel mixture by the spark.
Spark Plugs will usually have to gapped to the manufactures specifications found in the owners manual.

Over time a Spark Plug will become fouled because the air/fuel ratio may be set wrong,worn piston rings, carbon build up and other factors.
It is better to replace a fouled spark plug, rather then trying to clean it.

This is a genuine OEM replacement part, it is sold individually.
The purpose of the 16221-883-800 Carburetor Gasket is to prevent an air leak, which would cause the engine to run poorly.

It is advised to replace these gaskets when replacing or repairing the carburetor.

This is a genuine OEM replacement part, it is sold individually.
The purpose of the 16221-883-800 Carburetor Gasket is to prevent an air leak, which would cause the engine to run poorly.

It is advised to replace these gaskets when replacing or repairing the carburetor.