We Sell Only Genuine Generac ® Parts.
This battery charger is used with a variety of portable generators. It is supplied directly from original equipment manufacturer and it is sold individually. It is used to deliver power from an outlet to the unit. Please note that a weak or defective battery can damage the charger. Weak batteries are batteries with bad cells that would not hold charge. It is advised to test your batteries if you are unsure if the problem is in the charger or the batteries.
It is an authentic Generac replacement part. It is supplied directly from original equipment manufacturer for use with portable generators. This rubber foot helps to support the unit while absorbing shock to minimize vibrations. Includes one (1) shock absorber per order. Please note the screw used to secure this foot is sold separately.
It is an authentic part that is supplied by the original equipment manufacturer. This valve is designed for use with Generac portable generators. It is the special component that allows a user to shut-off fuel supply. The kit includes one durable plastic valve. It provides an identical replacement for a faulty or a missing item that was installed on a new unit. Refer to the owners manual and the diagrams of your model for the exact location and the correct installation. You may need pliers to disconnect the old valve and connect the new one.
This is an authentic replacement Generac carbon brush set designed for use with portable generators. Due to a physical contact with an armature, carbon brushes will gradually wear away requiring replacement. This assembly includes a plastic brush holder, two (2) carbon brushes with lead wires and terminals attached.
You would need a screwdriver to complete this job.
• Make sure the unit is unplugged
• Remove the old brushes and replace them with the new ones
• Reattach the cover and test the motor
This is an authentic part which is supplied by the original manufacturer for use with Generac portable generators. It is utilized to secure and provide a tight fit for the fuel tank valve. This is a high-quality replacement for a damaged or a missing hardware that was installed on a new unit. To ensure the correct location and application of this part, refer to the appropriate diagrams of your model. It is made of durable rubber and is sold individually. You may need pliers to remove and secure the bushing.