Carbon Brush

Genuine Porter Cable replacement part
includes 1 Carbon Brush with wire lead and brush spring attached.

• Worn brushes are often the cause of a poorly running motor
• Replacing brushes can fix an intermittent motor
• New brushes can restore a motor’s electric braking

Carbon motor brushes are one of the most commonly replaced power tool components.  Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement.  Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power.  A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned.  When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.

Brush Cap

This is a genuine Porter Cable replacement part, it is sold individually.
This Brush Cap is used on the model numbers shown below.
To remove this part ,simply use a flat head screw driver.
Don't use top much pressure on it, they do have a tendency to break.

Carbide Tipped Blade

This is a genuine Dewalt replacement part, it is sold individually.
The purpose of the 372105-01 Blade, is to plane wood material and leave a smooth finish.
There are two blades requires on each of the tools listed below.

This Blade is reversible.
To remove the blade ,loosen the bolts that secure the blades.
Use a screwdriver to begin sliding the blade out, then you can carefully remove it with your fingers.
Turn the blade around and insert back into the holder, making sure it is centered and not touching either side of the planer, fasten the bolts tight now.
Rotate the drum and repeat the process again.

Sprocket

Genuine Dewalt replacement part, this item is sold individually.
This Sprocket is used on the Dewalt Planers listed below to drive the feed rollers
There are four of these Sprockets used in each Planer.
The Sprocket has eight teeth, 5/8 bore, with a 3/16 key inside the bore.

Screw

This is a genuine Dewalt replacement part, it is sold individually.
The purpose of this screw is to secure the planer knives to the cutterhead on the planers shown below.
It is also used on the DW7351 Folding Table.
It is a allen head screw.
A complete set of 24 screws including the wrench can be ordered by using part number 5140067-11, the screws in the set are Torx heads.

Sprocket

Genuine Dewalt replacement part, this item is sold individually.
This is a Drive Sprocket that works in conjunction with a drive chain.
It is used on the Dewalt Planers shown below to drive the feed rollers.
Depending on the model number you have, as in case of the DW734 uses one.
The DW735 and the DW735X use four of this part.