How to Replace the Fuel Tank on a Troy-Bilt Super Bronco Tiller
This article will guide you through the process of replacing a broken or damaged fuel tank in a Troy-Bilt Super Bronco tiller.
How to Replace the Muffler on a Troy-Bilt Pony Lawn Tractor
In this article we'll walk you through the process of replacing the muffler in a Troy-Bilt Pony Lawn Tractor.
How to Replace the Lower Handle on a Troy-Bilt Super Bronco Tiller
This article will guide you through the process of replacing a lower handle assembly in a Troy-Bilt Super Bronco Tiller...
How to Replace the Starter Assembly on a Troy-Bilt Super Bronco Tiller
This article walks you through the steps of replacing a broken or damaged started assembly in a Troy-Bilt Super Bronco tiller.
Discussion for the Troy-Bilt 020245-0 2,200 PSI Pressure Washer
Post a Comment
Ask a question, answer a question, or post a comment!
Question: Loss Of Power
used my washer a couple of months ago and all was fine. Tried to use it yesterday and have no water power - no more than standard garden hose.....any ideas what is wrong?
Reply: Loss Of Power
Most low pressure issues with pressure washers are caused by an unloader valve that is faulty or corroded. I would start by removing the unloader valve and cleaning it and its housing. If it still won't pressurize then you will need to replace the valve. It is part #190628GS.
I hope this helps,
Question: Oil Drain Plug
I have a Troy-Bilt 020245-0 2,200 PSI Pressure Washer with a Briggs Stratton 4.5 hp engine. Access to the oil drain plug is almost impossible. I think it is a hex head plug but not sure and don't know the size. Anyone know the type and size on the plug?
Reply: Oil Drain Plug
I have the same model exactly. The owner's manual says that it is an 8mm hex (allen wrench).
Hope this helps.