Quick Fix: How to Replace the Blade on a Miter Saw
This article shows how to replace a miter saw blade on a saw with or without a blade lock.
How to Diagnose a Bad Power Cord or Switch
This article outlines the basics of power tool and appliance electrical diagnosis. You can use a multimeter to test tool and appliance cords and switches, the two parts usually responsible for electri...
How to Adjust a Miter Saw
Miter saws often need their bevel angles and miter angles adjusted, and this article explains generalized steps to make these adjustments on most miter saws.
How to Remove an Armature Bearing with a Vise
This article explains one backup method for removing armature bearings when a bearing puller isn't available.
Discussion for the Ryobi TS1301 10" Miter Saw
Post a Comment
Ask a question, answer a question, or post a comment!
Reply: Miter Pointer
When the manufacture stopped supplying the 303439-000 miter pointer, they did not come out with a replacement for it.
Question: Hole To Hole Distance
I doubt it is possable but ..... Could someone check the distance... On Center from left to right ...the outside mounting holes. That is to say the two holes that hold the fence to the bed. Yes I know there are 4 holes and if you want to include all of the measurements....ie: center to center on the two holes on the left side of the fence where those holes are the ones used to mount the fence to the bed of the saw... that would be fine but all I reall need is an answer to the first question.
Thanks for trying in any case!
When I cut a piece of wood with this 20 year old miter saw the wood is cut but the saw does not slow down like it used to when I released the trigger. What part is responsible to slow the saw down and stop real quick? Do I need a new saw? Help!
Accessories for the TS1301