Probably a dumb question.... is the Wire Lead the same as the spark plug wire on the ryobi 700r handheld trimmer? Thanks

After running for about 90 minutes, the plastic blade guard ripped off from the screws. It was as if it was "old plastic". I have most of the pieces....is there any warranty on this product?

which way does it turn to remove

My trimmer will some times run if I leave it on partial choke. If I put in on no choke it stops and is hard to restart. Do you think the carburetor repair kit will fix problem? It acts like it runs out of gas.

should the hole be on the top or bottom of the carb? I missed that when i took it off. Now I need help.

what is the size of the fuel lines (ID)

On My Muffler this Bottom Port is Melted off, what would be the Cause of that?
Which in turn melted a Hole through the Bottom of my Carb/Air Clnr Housing assembly.

I have a USA 700r trimer, when it runs it won't idle and when I turn it off gas leaks out of the carb. Any suggestions? Would this be a fuel line thing? Thanks!

How do I replace recoil pulley assembly?

At what 2 points does the recoil spring attach to? I know the inter lip attaches it self to the pulley retainer assembly, but I am not sure where the outer lip attaches to.

is there a diagram of the routing of the fuel lines on a 700r trimmer? I am replacing all the fuel lines and now it won't start!

I need to disassemble the head assembly for repairs. What is the right way to remove the retainer ring?

The return fuel line came off. How can I put it back and where do I put it?

It is hard to pull the starter rope.

I have a Ryobi 770r trimmer. The priming bulb does not seem to be sending gas to the carburetor and/or I am getting no spark as the trimmer is not firing at all.

Does the primer pump need to be connected in order to start or can it be blocked off?

What is the second hole in the bottom of the fuel tank for?

I need both adjustment screws on top of the carb for the 700r and I do not see them listed. Do you have them?

What is the gap on a magneto?

[SIZE="2][/SIZE]

Are the fuel and return lines the same size in diameter? If so, where can a length
for both be purchased?

can anyone tell me why this trimmer will run for about 5 sec and then quit? I have changed the gas lines so far still no good:confused

Recoil pulley wares out to fast, and trying to get the recoil spring back in side is near impossible. who ever designed that should be shot. Now the coil/moudule assembly is bad and costs too much to replace. Just spent $19.00 for pulley now I'll have to junk it.

the trimmer is great to use but I have to replace the recoil starter pully about once a year because it is made out of plastic instead of metal.

i purchased ryobi weed trimmer (model #700r) on sale about 6 yrs. ago. at 1st i wasn't sure of how it was going too meet my need as far as the size(31cc). well i 'm still quite pleased with the trimmer. my only compliant is rewinding the line.i buy a spool because it's more economical for me. it always seems i have too take off the spool and rewind at least once before it runs out.