Repair Parts Home Power Tool Parts Milwaukee Parts Milwaukee Sawzall Parts
Milwaukee 6527-21 (SER 963B) Super Sawzall w/Quik-Lok Blade Clamp Parts
How to Diagnose a Bad Power Cord or Switch
This article outlines the basics of power tool and appliance electrical diagnosis. You can use a multimeter to test tool and appliance cords and switches, the two parts usually responsible for electri...
Power Tool Care and Maintenance 101
This article suggests guidelines for power tool care and maintenance. It also describes information tools available at eReplacementParts.com.
Blade Holder Worn
Time Spent Repairing:
Entry Date:2014-03-10 15:09:08
0 of 0 customers found these instructions helpful
The Quik-Loc retainer which holds the blades in place was worn
The only difficulty I encountered was removing the clip which holds the retainer mechanism in position. The 'clip' fits into a grove on the reciprocal shaft. Unlike a 'C' clip this retainer encompasses the entire circumference of the shaft. I had to use a small (repeat SMALL) screwdriver to dislodge the clip. After removal of the clip the remaining parts are easily removable. eReplacement parts has a great video on the installation of this part also.-----http://www.ereplacementparts.com/article/1572/How_to_Change_the_Milwaukee_Sawzall_QUIKLOK_Blade_Clamp_Assembly_.html
Discussion for the Milwaukee 6527-21 (SER 963B) Super Sawzall W/Quik-Lok Blade Clamp
Post a Comment
Ask a question, answer a question, or post a comment!
Question: Sawzall Dead--switch Or Variable...
milwaukee sawzall corded, variable speed 6527-21 ser# 963B
Nothing happens when trigger is pulled; worked fine one minute, next minute it was dead. Tried different outlets, checked breaker, etc.
Pulled it apart and I seem to have continuity where I should, but it's hard to tell because the switch contacts are not exposed.
I suspect either the switch or the variable speed control; how do I figure out which it is? Do I just have to buy one, try it and if it doesn't solve the problem, buy the other part?
Reply: Sawzall Dead--switch Or Variable...
To save a lot of trouble just replace both.Chances are Milwaukee has updated the switch unit anyway so to do a clean repair replace both.Hope that helps.Good luck.
Question: Sawzall 6527-21 Model 963C
I have a Milwaukee 6527-21 (SER 963C) Super Sawzall w/Quik-Lok and the quick lock fell apart. How do I get it back together?
Reply: Sawzall 6527-21 Model 963C
How to Change the Milwaukee Sawzall QUIK-LOK Blade Clamp Assembly : eReplacementParts.com
hope this helps...
Accessories for the 6527-21