Repair Parts Home Lawn Equipment Parts Echo Parts Echo Blower Parts Echo Handheld Blower Parts
Echo PB-2100 (Type 1E) (After S/N 001001) Handheld Parts
How to Test a Small Engine for Spark
If your small engine isn't starting, you'll need to diagnose many issues including the spark plug. This video walks you through the steps of how to test for a spark using a spark tester.
Quick Fix: How to Clean a Spark Arrestor Screen on a Small 2-Cycle Engine
This repair article will instruct you how to repair a dirty or damaged spark arrestor on your small engine.
Quick Fix: How to Replace the Spark Plug in a Small Engine
This article will help you replace the spark plug on a small engine which will help get your gas powered equipment up and running again.
How to Replace the Fuel Filters in Your Outdoor Power Equipment
This article will help you troubleshoot your fuel-line replacement repairs.
Time Spent Repairing:
Entry Date:2013-11-19 16:04:30
1 of 1 customers found these instructions helpful
Primer bulb cracked, decided to rebuild carburetor
The 12538108660 Primer bulb was split. While I had it apart I figured I\'d rebuild the carburetor. The job was straight forward and easily accomplished with the help of ereplacement parts website. They have a nice tutorial on how to rebuild carburetors. - http://www.ereplacementparts.com/article/6766/How_to_Rebuild_a_TwoCycle_Engine_Carburetor.html
Time Spent Repairing:
Entry Date:2013-12-19 12:37:48
0 of 0 customers found these instructions helpful
blower would not run
Remove carburetor, take apart completely. put into a ultrasonic cleaner using simple green 10 to 1 with tap water. Warm water works best. Remove, blow out all openings and install new carb kit. When replacing hi and low needle valves both should come out one and a half turns from closed position to start. Blower started right up works like new.
Discussion for the Echo PB-2100 (Type 1E) (After S/N 001001) Handheld
Post a Comment
Ask a question, answer a question, or post a comment!
I recently installed kit 12530020560. I also installed a new fuel filter and new air filter. I can get the blower started but to keep it running I have to manipulate the choke to keep it running. I need a little help please!
I don't know if you did this or not. But when you install any type of repair kit it is always advisable to thoroughly clean the carburetor. The small passageways can get dirty or clogged. We do have an article and video on How to Clean a 2 Cycle Engine Carburetor.
Hope this helps,
Question: HAND Blower
Blower won,t fire up? Pull role nlike not enght gas or won,t fire up.
Reply: HAND Blower
First check your spark plug, making sure you do have a spark. The best way to do this is with a spark plug tester found in most big box stores. You may also have a dirty or clogged carburetor. We have a video and article on how to clean it properly. Here is a link to it. How to Clean a 2 Cycle Engine Carburetor. You may also want put in a 12530020560 repair kit. And a new 13120507320 fuel filter.
Question: Carb Replacement
Replaced carb fuel lines and wont stay running when prime it the bulb gets stuck and slowly comes back.
can it be the tank vent?
Reply: Carb Replacement
That sounds like the carburetor needs to be rebuilt. The rebuilt kit is part #12530020560. We have a video that might help with the repair. http://www.ereplacementparts.com/article/6766/How_to_Rebuild_a_TwoCycle_Engine_Carburetor.html
I hope this helps!
Question: Primer Bulb
I disassembled, cleaned, and reassembled the carburetor as outlined in your video. Changed the primer bulb along the way. Seem to have flow through all ports before tightening down plate holding bulb. After tightening, I can't get any fuel to move when pushing the bulb and the resistance on the bulb feels almost airtight. Any ideas?
Question: Carb Choke
The first thing that broke on my Echo PB-2100 was the Carb Choke lever. I dont see it on the parts list or drawings. In fact a few parts shown have no part listed below by the item number, and a few are listed wrong by item number (A10, 11 & 12 for example). How can I replace my choke lever?
Reply: Carb Choke
check out page 3 item 7
Reply: Carb Choke
The choke is built into the Air Cleaner Case Assembly. Here is a link to the image and part number. P021002921.
Hope this helps,
Question: Rope Reel Question
Question about the rope reel on the blower.the cord comes out not all the way and does start but takes a lttle before catching the pawl assembly. Which I replaced already. Does anyone think it could be the rope reel? With the little nubs not catching? They reall don't look bad what are your thoughts. Thanks!!
Question: Echo PB 2100 Carburetor
Priming bulb does not pull gas from tank. I have checked bulb, filter and gas line which are good. The bulb moves air through the return hose. Is there a check valve I am missing?
Reply: Echo PB 2100 Carburetor
I would guess that the carb will need to be rebuilt. Sometimes the gas that is left in the carb will become varnish like and stick the reed valves to the carb body. When this happens the fuel can't flow though the carb. Rebuilding the carb will fix the problem. The rebuild kit is part #12530020560.
I hope this helps,
Question: Fuel Tank Vent Connection
Where does the fuel tank vent connector go? It comes out of the tank grommet, but I do not see where it reconnects at other end.
Reply: Fuel Tank Vent Connection
It just sits under the carb area open to the air. It doesn't attach to anything.