Repair Parts Home Power Tool Parts DeVilbiss Parts DeVilbiss / Excell Pressure Washer Parts
DeVilbiss / Excell VR2522 Type 0 Gas Pressure Washer Parts
How to Winterize a Pressure Washer
Learn how to properly winterize your pressure washer by adding antifreeze to the pump, draining the oil, and adding oil to the piston. Read the full article for a step-by-step guide.
Quick Fix: How to Replace the Outlet Connector on a Karcher Electric Pressure Washer
Learn how simple it is to replace the outlet connector on your Karcher electric pressure washer by reading this repair article.
A Quick Fix: How to Replace the Pump on a Pressure Washer
This article outlines the steps to replace or service the pump on your pressure washer. Doing this repair yourself will save you money and time.
How to Start a Pressure Washer
Prevent pressure washer performance problems with this article's steps for correct pressure washer setup. Correctly clearing air from your pressure washer also prevents damage.
Discussion for the DeVilbiss / Excell VR2522 Type 0 Gas Pressure Washer
Post a Comment
Ask a question, answer a question, or post a comment!
Question: Pressure Washer Wheels
The wheels of this Excell pressure washer (model # VR2522), which is all plastic have come off the nut. Do I need new wheels or can the button snap (part # D30492 - .302 diameter) be used to correct this? Thanks, D Lang
Question: No Pressure
My VR2522 has no pressure. There is water flow through the unit but no pressure.
Reply: No Pressure
I bought a used washer with that problem. I took the end of the wand off, put it back on and it worked. Not sure if it was debris or perhaps airlock.
Am wondering if this unit is supposed to idle down when not spraying?
Question: Excell Pressure Washer
My Excell pressure washer, VR2522, starts fine but when I close the throttle it dies out.
Reply: Excell Pressure Washer
I believe what you're talking about is the choke. Run it a minute or so adjusting the choke as yo go. Should run fine after that.
Reply: Vr2522 Unloader Valve
Did you find out how to set the unloader valve. Mine leaks