The motor runs fine but I can't get any pressure out of the hose?
Someone told me to replace the unloader valve? It looks like there are two pieces to it?
The Type number is usually listed on the model number tag near the model number and serial number. In many cases, models of the first Type will not have the type number listed on it. in the case of your pressure washer the first run is the Type 0 and it may not have that listed on the tag. If it does not list the Type you would just assume that it is a Type 0.
I hope this helps with your repair!
-Mark
Pump Question by Jason Powell
I have the vr2500 pressure washer and sounds like it builds up pressure because the engine is under a load but when I pull the trigger on the wand the pressure goes away. Then when I release the trigger it builds up again. I had the pump apart but everything looks ok. Any help would be appreciated