My 40-601 type 1 Delta Scroll saw blew a 1/4 Amp fuse. I could not find a 1/4 Amp replacement so I used a 1/2 Amp. Now the saw will only run at maximum speed regardless of the position of the speed control knob. Is because of the fuse or is there another problem?
Would there be anything to look into instead of just replacing the control panel of the saw? I have no control of the blade speed.
Read this post in the
forums
I have a 40-601 delta 18 in. scroll saw. It will operate at low speed or hi-speed but nothing in-between. Any help? Thanks.
Read this post in the
forums