Repair Parts Home Power Tool Parts Delta Parts Delta Table Saw Parts
Delta 36-979 10" Left-Tilt Contractor's Saw Parts
How to Diagnose a Bad Power Cord or Switch
This article outlines the basics of power tool and appliance electrical diagnosis. You can use a multimeter to test tool and appliance cords and switches, the two parts usually responsible for electri...
Power Tool Care and Maintenance 101
This article suggests guidelines for power tool care and maintenance. It also describes information tools available at eReplacementParts.com.
Discussion for the Delta 36-979 10" Left-Tilt Contractor's Saw
Post a Comment
Ask a question, answer a question, or post a comment!
Question: Dado Insert
does this insert work with delta model 36-979 left tilt contractor saw
Reply: Dado Insert
The item number 36-847 left tilt dado insert is used on the Delta 36-979 table saw.
can thhe the riving knife graurds on new PORTER CABLE saw retofit to a 36-979
I haven't seen a retrofit kit yet to change the standard splitter style guard to a riving knife system. Hopefully Delta will design one to go on their late model table sawS soon.
I made a cut. I turned the saw off to adjust for another cut. I turned the saw back on but the motor started turning very slow. Do they have a start capacitor? I know the motor didn't overheat. I had just started working, the saw had only ran for thirty seconds and the motor didn't feel warm.
Question: No Manual / Preassembled Wrong
I purchased my tablesaw p reassembled as the display model at Lowes. Unfortunately they lost the owners manual. since bringing it home I have found out the person responsible for assembling the saw should be fired. many things were wrong, including the blade on backwards. ( I didn't notice till the basement filled with smoke.) My biggest dilemma now is the motor mount. I am not sure how it is supposed to be mounted but I know the belt is not supposed to rub on the frame. I cannot figure the adjustment correctly. any help in this direction would be a great help!
Question: Extracting Arbor On Delta 10' Ta...
Is there anyone out there know the proper name of the tool used to take out the BEARING CLOSURE NUT when taking out the arbor on the 36-979 delta 10' table saw.And where I might be able to buy this tool :(
Reply: Extracting Arbor On Delta 10' Ta...
I have not seen a special tool to remove the closure nut. I have always used a flat screwdriver and a hammer to remove closure nuts. Put the point of the screwdriver against the shoulder of the groove on the closure nut. Tap the screwdriver with a hammer and the nut will loosen. Once loosened you can unscrew the nut.
I hope this helps you get your saw running again!
Accessories for the 36-979