How to Diagnose a Bad Power Cord or Switch
This article outlines the basics of power tool and appliance electrical diagnosis. You can use a multimeter to test tool and appliance cords and switches, the two parts usually responsible for electri...
How to Replace the Blades on a Hand-Held Planer
For a planer to do its job, you need to make sure the blades are as sharp as can be. This article will walk you through the steps needed to change your Planer blades so you always get the best perform...
Power Tool Care and Maintenance 101
This article suggests guidelines for power tool care and maintenance. It also describes information tools available at eReplacementParts.com.
Discussion for the Delta 22-675 Type 1 Planer
Post a Comment
Ask a question, answer a question, or post a comment!
Question: Bed Roller Bearing Replacement D...
How do I remove the bed roller and bearings from the delta 15 inch planer? Each side has a set screw and an eccentric stud, I loosened the set screw and tried backing out the eccentric stud but nothing seems like it wants to come out. Any help?
Reply: Bed Roller Bearing Replacement D...
You may want to try using some type of penetrating oil or spray on the Eccentric Studs and let it soak in for a while. I have seen this happen before. After letting it soak for a good while try twisting them back and forth and they should release from the table. To remove the bearings from the bed roller. A slide bearing puller will get the bearings out. Or sometimes you can tap on the end of the bed roller with a mallet and they will come out.