How to Replace the Bearing Cap Assembly on a Ryobi Random Orbital Sander
If a damaged sander has been grinding at your nerves, this article will show you how to quickly remove and install a new bearing cap assembly.
Quick Fix: How to Replace the Platen on a Belt Sander
Replacing the platen on a belt sander is a straightforward repair, but getting the fasteners back in place can be tricky. Read this article to learn a handy trick to make re-installing the platen easi...
How to Diagnose a Bad Power Cord or Switch
This article outlines the basics of power tool and appliance electrical diagnosis. You can use a multimeter to test tool and appliance cords and switches, the two parts usually responsible for electri...
How to Remove an Armature Bearing with a Vise
This article explains one backup method for removing armature bearings when a bearing puller isn't available.
Discussion for the Bosch PBS75A (0603270139) Belt Sander
Post a Comment
Ask a question, answer a question, or post a comment!
Question: Replace Drive Belt To Bosch Belt...
Hi. I'm trying to replace the drive belt to my Bosch Sander PBS75A.
I assume that to get the belt (part 33) onto the toothed pulleys (parts 31 &843)
I must get one or both pulleys off their shafts - but how?
Thanks in advance for any help.
Reply: Replace Drive Belt To Bosch Belt...
remove top of handle (1) and front plastic cover (49) with the three torx screws (819)
This reveals 4 silver, flat-head screw that holds the motor to the base, remove these, and you can then tilt the top so that there is slack in the belt to remove it and replace, then re-assemble
Accessories for the PBS75A